Transducer Connector 10 Pin for Furuno

This plug is the one used as standard on transducer cables for Furuno equipment. It can be used as a replacement on transducers with a missing connector. The connector is available only on a short length of cable, which should be spliced to the transducer cable using the Airmar-approved junction box.

If you have a transducer that is made as a Mix and Match version (ie a short 2m cable attached to the transducer plus a longer 8m brand-specific cable) then the best way to convert the transducer to a different brand of electronics is to change the brand-specific Mix and Match cable.

If you have an older transducer with a fixed 10m cable you should not use this connector to convert it for use with Furuno but instead use one of our Airmar adapter cables.

Transducers using this connector have a part number ending in '-10F' in our listings.

A wiring diagram for this connector is available under 'Wiring Diagrams' on our Expert Advice page.