Transducer Connector 7 Pin for Raymarine

The plug used by Raymarine on transducer cables for the DSM300, DSM30 and the older DSM250 is not available separately. The only way to acquire this connector is to buy an accessory cable (see below) with this connector on one end, cut the cable, discard the unwanted end, and splice the cables together using the Airmar-approved junction box.

If you have a transducer that is made as a Mix and Match version (ie a short 2m cable attached to the transducer plus a longer 8m brand-specific cable) then the best way to convert the transducer to a different brand of electronics is to change the brand-specific Mix and Match cable.

If you have an older transducer with a fixed 10m cable you should not use this connector to convert it for use with Garmin, Navman or Northstar but instead use one of our Airmar adapter cables.

Transducers using this connector have a part number ending in '-RAY' in our listings.

A wiring diagram for this connector is available under 'Wiring Diagrams' on our Expert Advice page.